Product Manual

www.burcam.com
2190 Dagenais Blvd. West TEL: [phone]
LAVAL (QUEBEC) FAX: [phone]
CANADA
H7L 5X9 [e-mail]
INSTALLATION
INSTRUCTIONS
MODEL
400700
GRINDER PUMP
Please read these
instructions
carefully. Failure
to comply to
instructions
and designed
operation of
this system,
may void
the warranty.
Your pump has been carefully packaged at the
factory to prevent damage during shipping.
However, occasional damage may occur due to
rough handling. Carefully inspect your pump
for damages that could cause failures. Report any
damage to your carrier or your point of purchase.
© 2015 BURCAM Printed in Canada 311147
INITIAL START UP PROCEDURES:
1. Inspect the pump and the sewage tank for
any obvious condition that may necessitates
cleaning, correction, adjustement or repair.
2. Assure that the pump is secure and vertical
for proper operation.
3. Assure that there is adequate clearance
from any combustible materials or structure.
Stored materials must be kept away from the
pump. Shelves or cabinet structures must
not be in close proximity over the pump.
4. Assure that the motor is securely plugged
into a proper ‘GFCI’ electrical outlet.
5. Test the ‘GFCI’ outlet by pressing its
test switch. This should prove that the
outlet is energized and will trip off to
protect against a ground fault. Be sure to
reset the ‘GFCI’ by pressing its reset switch.
(Repeat this step monthly)
6. Lift the oat to assure that the pump will
start when required. (Step 7 below will test
submersible pumps with enclosed oats).
7. Pour pails of water in the sewage tank to turn
the pump on. Assure that any check valve
present will permit the sewage to ow.
8. Observe that the plumbing can pump
the sewage safely out of the residence.
(Repeat this step monthly)