Product Manual
SAFETY INSTRUCTIONS:
Before installation and operation, follow these procedures:
Check with your local electrical and plumbing codes to ensure you comply with the regulations.
These codes have been designed with your safety in mind. Be sure you comply with them.
A separate circuit must be lead from the home electrical distribution panel properly protected with
a fuse or a circuit breaker. We also required that a ground fault circuit be used as well as a ‘GFCI’
receptacle. Consult a licensed electrician for all wiring.
The ground terminal on the three prong plugs should never be removed. They are supplied and
designed for your protection.
Never make adjustements to any electrical appliance or product with the power connected.
Do not only unscrew the fuse or trip the breaker, remove the power plug from the receptacle.
ELECTRICAL CONNECTION:
For pumping systems using more than one pump, each pump needs to be connected to a separate
dedicated circuit protected by a fuse or breaker. This way, the power supply of one pump will not stop
operating if the fuse of one of the pumps burns or if the breaker of one of the pumps trips.
A
B
C
D
MATERIAL REQUIRED FOR SEWAGE PUMP APPLICATION:
Desired length of ABS/DWV 2’’ pipe, to link up from pump discharge to waste or drain existing pipe.
Required quantities of 2’’ ABS/DWV elbow (s) and/or other tting (s) to run the discharge line.
1 only 1 1/4’’ male adaptor to 2’’ slip, to connect the discharge pipe to the pump.
Desired length of ABS/DWV 3’’ pipe and required quantities of 3’’ ABS/DWV elbow (s) and/or other
tting (s) to run the vent line.
1 only 2’’ union check valve # 450457.
1 only 18’’ X 30’’ minimum size sewage basin like # 400420.
Teon tape and ABS cement.
TOOLS:
Screwdrivers, hacksaw to cut pipe, knife to assist in pipe cutting, round le to smooth pipe ends, pipe
wrench, adjustable wrench, 1/4’’ drill bit and drill.
Ensure that you have a gas tight cover for your sewage basin and 3’’ ABS/DWV vent piping.
NOTICE
This unit have been designed to pump water only. This unit is not designed for applications involving salt
water, brine or any other liquids including petroleum products. Use with salt, brine or any other liquids
including petroleum products will void the warranty.
2