User guide

31
Wiring
Type 8025 / 8035
Tab. 5: Positioning of the Source / Sink selector depending on the wiring of the current output of a version with relays
Wiring the 4-20 mA output Position of the Source/Sink selector on a version with relays
Not wired (jumper wire in place) SOURCE
Sourcing mode SOURCE
Sinking mode SINK
8.3.3. 115/230 V AC selector
The 115/230 V AC selector makes it possible to configure the supply voltage of the device in a 115/230 V AC version.
230V
115V
→ Energize the device with a
230 V AC voltage.
→ Energize the device with a
115 V AC voltage.
Fig. 24: Supply voltage selector on a 115/230 V AC version
8.4. Wiring the 8025 in a compact version and the 8035, with or
without relays, with cable glands
8.4.1. Wiring instructions
Seal the unused cable gland using the stopper gasket supplied to make sure the device is tight.
→ Unscrew the nut of the cable gland.
→ Remove the transparent disc inside the cable gland.
→ Insert the stopper gasket.
→ Screw the nut back.
→ Lift the transparent lid after having unfastened the screw.
→ Untighten the 4 screws then remove the cover from the device.
→ For the versions with relays, insert the cable clip.
Supply
12..36Vdc
FLOW SENSOR
COIL NPN
SOURCE SINK
L+
L-
PE
P-
P+
NC
L+
L-
PE
P-
P+
Iout
PULSE
OUTPUT
Without
With
Relays
PE
→ Before wiring the device insert the supplied cable
clips into the slots of the electronic board and of the
115/230 V AC power supply board if the device has
such a board.
Fig. 25: Inserting the cable clips
→ Pass the cables through the cable glands.
→ Set the selectors according to chap. "8.3".
→ Connect the terminal block according to the indications of chap. "8.4.2" to "8.4.6".
English