User Manual

8.6.4. Configuring the filter

This parameter makes it possible to dampen the fluctuations ot the

display.

Ten filters are available.

FiltER FiltER 0

tOtAl

→ Choose the filter.

→ Confirm

FiltER 9

0......9

Fig. 20: Diagram of the "FILTER" parameter of the Configuration level

8.6.5. Resetting both totalizers

tOtAl REs NO

END

→ Choose to reset the

two totalizers or not.

→ Confirm

REs YEs

Fig. 21: Diagram of the "TOTAL" parameter of the Configuration

level

The daily totalizer can be reset from the Process level (see

chap. 8.5).

9. MAINTENANCE AND

TROUBLESHOOTING

9.1. Safety instructions

danger

Risk of injury due to high pressure in the installation.

• Stop the circulation of fluid, cut off the pressure and drain the

pipe before loosening the process connections.

Risk of injury due to electrical voltage.

• Shut down and isolate the electrical power source before car-

rying out work on the system.

• Put the power switch to OFF before carrying out work on the

device.

• Observe all applicable accident protection and safety regulati-

ons for electrical equipment.

Risk of injury due to high fluid temperatures.

• Use safety gloves to handle the device.

• Stop the circulation of fluid and drain the pipe before loosening

the process connections.

Risk of injury due to the nature of the fluid.

• Respect the prevailing regulations on accident prevention and

safety relating to the use of aggressive fluids.

Maintenance and troubleshooting

Type 8025/8035 battery powered

English