User Manual

Warning

Risk of injury due to non-conforming maintenance.

• Maintenance must only be carried out by qualified and skilled

staff with the appropriate tools.

• Ensure that the restart of the installation is controlled after any

interventions.

9.2. Cleaning the device

The device can be cleaned with a cloth dampened with water or a

detergent compatible with the materials the device is made of.

Please feel free to contact your Bürkert supplier for any additional

information.

9.3. Cleaning the flow sensor of the

8025

note

• Use a cleaning product that is compatible with the materials the

flow sensor is made of.

• Do not use any abrasive acting materials.

note

After cleaning of the flow sensor:

• Rinse the flow sensor.

• Check the seal and replace it if necessary.

9.4. Replacing the batteries

Dispose of the used batteries in compliance with the pre-

vailing legislation.

→ Open the housing as indicated in Fig. 10 chap. 8.2.

→ Disconnect the flow sensor to make easier the access to the

batteries.

→ Take off the batteries connectors.

→ Replace the batteries one after the other to keep the data regis-

tered in the device.

→ Plug the connectors onto the batteries.

→ Reconnect the flow sensor.

→ Close the cover.

→ Tighten the screws.

→ Close the lid.

→ Tighten the screw.

Maintenance and troubleshooting

Type 8025/8035 battery powered

English