MPO-IQ Installation, Operating, and Service Instructions
18
Figure 8: Bafe Orientation in Flueways
Step a. Install stainless steel bafes provided in
miscellaneous parts carton as follows, refer to Table
3 and Figure 8:
• Model MPO-IQ84 - To install ueway bafe in 3
rd
pass on left side of boiler, hold bafe with word
"Left" readable at the top. Slide bafe in ueway
until position tab touches ns on left side of 3
rd
pass ueway. To install ueway bafe in 3
rd
pass
ueway on right side of boiler, hold bafe with
word "Right" readable at the top. Slide bafe in
ueway until position tab touches ns on right
side of 3
rd
pass ueway.
• Model MPO-IQ115 - To install ueway bafe in
3
rd
pass on left side of boiler, hold bafe with word
“Left” readable at the top. Slide bafe in ueway
until position tab touches ns on left side of 3
rd
pass ueway. To install ueway bafe in 3
rd
pass
ueway on right side of boiler, hold bafe with
word “Right” readable at the top. Slide bafe in
ueway until position tab touches ns on right
side of 3
rd
pass ueway. To install ueway bafe
in 2
nd
pass on left side of boiler, hold bafe with
word “Left” readable at the top. Slide bafe in
ueway until position tab touches ns on left side
of 3
rd
pass ueway. To install ueway bafe in 2
nd
pass ueway on right side of boiler, hold bafe
with word “Right” readable at the top. Slide
bafe in ueway until position tab touches ns
on right side of 3
rd
pass ueway.
• Models MPO-IQ147, MPO-IQ189 and MPO-
IQ231 - To install ueway bafe in 2
nd
pass
ueway on left side of boiler, hold bafe with
word "Left" readable at the top. Slide bafe in
ueway until position tab touches ns on right
side of 2
nd
pass ueway. To install ueway bafe
in 2
nd
pass ueway on right side of boiler, hold
bafe with word "Right" readable at the top. Slide
bafe in ueway until position tab touches ns
on left side of 2
nd
pass ueway.
NOTE: 2
nd
and 3
rd
pass ueway bafe are not
interchangeable.
6. Close the burner swing door and securely seal the door
to the boiler front section by reinstalling the hardware and
securing the door using procedure previously outlined in
Paragraph D of this section.
NOTICE
When securing burner swing door make sure door
is drawn-in equally on both sides.
II. PACKAGED BOILER ASSEMBLY - TRIM & CONTROLS (cont'd)