BURR KING MFG. CO., INC 1220 Tamara Lane Warsaw, MO 65355 www.burrking.
BURR KING MFG. CO., INC. 1220 TAMARA LANE WARSAW MO 65355 WWW.BURRKING.COM (660) 438-8998 (800) 621-2748 FAX (660) 438-8991 Safe operation and good practice use of your BK-100 dust collection system April 2001 The BK-100 dust collection system is designed to accept up to two dust inlets. Dust is drawn into the BK100 by its onboard air suction system. The air stream and dust is passed through a filter bank where a significant amount of the dust is removed from the air stream.
TABLE OF CONTENTS Dry Air Dust Bags Contaminated Dust Bags Changing/Installing Dust Bags Blower Replacement Parts list Dust Bag Assembly Dust Bag Installation
DRY AIR 1.0 Air entering a bag house type dust collector must be dry and oil free. DUST BAGS 2.0 Dust bags are made from a dacron or shaker felt filter material. 2.1 Dirty Dust Bags: As air containing particles is drawn through the dust bag, the particles are trapped on the outside of the bag. 2.1.1 A certain amount of particulate matter will always remain on the outside of the bag, even after shaking. This is normal and greatly improves the efficiency of the bag as a filter.
CONTAMINATED BAGS 3.0 The word "contaminated" is being used to describe a dust bag that has become coated with a material outside the normal material the collector is collecting. 3.1 The usual materials that contaminate a dust bag are water, oil, or grease. 3.1.1 A very small amount of either water, oil, or grease will contaminate all of the bags in the dust collector. This results in a complete change of dust bags. 3.
CHANGING FILTER BAGS 4.0 Remove plenum or plenum panels above dust bags. 4.1 Release clamps holding dust bags, than remove bags. INSTALLING NEW DUST BAGS 5.0 Replace foam seal around bag openings before putting in new bags. (See page 7 for dust bag installation.} 5.1 Replace dust bags and reinstall clamps. Be sure bags are sealed together and around edges of bag modules. 5.2 Reinstall plenum or plenum panels. BLOWER 6.0 There are two (2) types of blowers used to operate I.C.M.
BLOWER (Cont.) 6.2 Standard rotation furnished is for clockwise rotation looking down at motor side. All motors must be overload protected when connected or warranty is void. 6.3 The belt drive blowers are furnished with three (3) phase totally enclosed fan cooled motors at 1750 R.P.M. and carry their manufacturers' warranty. The blade or wheel is constructed of all welded steel and dynamically balanced. It is designed for higher efficiency, handling fumes, gases or air containing fine particles. 6.
DUST COLLECTOR REPLACEMENT PARTS LIST PART NO.
