USER Manual Owner's manual

Operating guidelines

Outgoing call

Briefly press down on the call button to activate the voicetag function.

The device says: Enter voicetag. Begin the call with a voicetag. If the

number dialled is busy, you can begin to redial. To do so, hold down the

call button (for two seconds). The device says: Redial.

If you announce a non-saved voicetag then the device says: Voicetag

is not available. CC 9058 returns to standby mode.

Briefly press down on the end call button to end the voicetag function,

the active call or the redialling. If you make a call and briefly press

down on the call button, the private mode is then started. The call is

then forwarded to the mobile phone.

Incoming call

If a caller transmits its number, the device will read out this number:

05732xxxxx. If the caller has hidden their number, then the device

says: Unknown caller. Briefly press down on the end call button to

refuse the call. The device returns to standby mode. Briefly press down

on the call button to accept the incoming call.

Setting the volume

If you have coupled your telephone with the car kit, it is possible to set

the volume for each of the functions Speech, Music and Menu An-

nouncements separately. After you have set the volume and discon-

nected the telephone from the system, connect the telephone again,

and the selected volume will be stored. Press down the horizontal but-

tons to gradually increase or decrease the sound during an active con-

versation. A high signal tone sounds when the maximum volume has

been reached. A low signal tone sounds when the minimum volume has

been reached. But you can also go over the buttons with your fingers

(both directions).

Disconnecting a telephone

Hold down (for three seconds) the end call button to disconnect the

telephone. The device says: No telephone is connected.

Turning off CC 9058

When leaving the vehicle and turning off the engine, you should also

switch off the CC 9058.