Operation Manual

26
Operating guidelines
If your contacts are stored in the telephone’s memory, then depending
on the type of mobile phone, you can allocate four or more telephone
numbers to a single contact. The terms are not standard and may have
different designations depending on the manufacturer of the mobile
phone, or can be set by you yourself*:
„HOME“,
„MOBILE“,
„WORK“,
„GENERAL“.
* This function depends on your mobile phone.
Some mobile phones support these categories only partly, however, or
not at all. To nevertheless display the telephone numbers, unknown
entries are listed within your contacts using the <Number> category.
You get a maximum of just one number from the SIM card, however
(this is always designated with SIM), and four numbers from the tele-
phone memory. If categories are only partly supported, the listing can
subsequently be mixed. Example:
Private
+44...
Mobile
+44...
Number 1
+44...
Number 2
+44...
SIM
+44...
If you say only „NUMBER“, all stored entries under this name will be
read aloud. This command is not active in the event of operation via the
Touchscreen.
In case you have stored more than one telephone number under a
contact name, you can also directly call through the category, e.g.
„DIAL JOE BLOGGS HOME“.
Dial number 1
Number
Dial office
Dial mobile
Dial home
Dial general
Dial sim