Operation Manual

If a call is received by both mobile phones at the same time, preference

is given to the primary mobile phone. You will be displayed the incom-

ing call on the other mobile after accepting or declining the first call.

You are then able to end the first call at short notice and to also decline

the second call (pressing to the right of the red receiver both times), or

to end the first call and to accept the second call directly (press the

symbol on the left). Holding the first call isn’t possible, as the calls are

not being made on the same telephone number. The conference mode

which is described in the instructions below is not possible between the

two mobile phones.

If two or more mobile phone signatures are saved and the Multipoint

function is activated, then the mobile phones will be sought and con-

nected in the order in which they are listed in the telephones list – posi-

tion 1 and position 2. In addition to the first telephone that is connected,

you will then also be shown the second telephone in the main menu.

If a number of signatures from different mobile phones have been

saved (from several different drivers) it may be the case that their order

does not suit your requirements. To be able to define both telephones

and their order for the multipoint function, you can set one mobile

phone as standard (as telephone 1) and another mobile phone as tele-

phone 2. If you do not set the second telephone then the HFCK will

complete a full search of the telephones list twice over. If the HFCK

does not find a second active telephone (because the

Bluetooth

func-

tion has not been activated, for instance), you must either connect the

second telephone manually via the telephone list, or deactivate the

multipoint function and then activate it again.

Via the „SWITCH PHONES“ command in the main menu, you are

able to swap the priorities of the mobile telephones.

Switch phones