Operation Manual

14
Operating guidelines
If the voice control function is active then the corresponding menu ap-
pears in the display, or the details of the particular function that has
been activated. In the following the individual menu points will be ex-
plained.
Dial Joe Bloggs
With this voice command (is not shown on the display) you can immedi-
ately call a contact from your telephone book with active voice control.
Note:
When doing so, it is important that the stated name ex- X
actly corresponds with the entry stored in the phonebook.
Please note that telephone book entries, which are only
shown in capital letters must be spelt out. Example: ADAC.
If the names have been reversed then the command changes to:
„DIAL BLOGGS JOE“.
Dial number
It makes sense to divide telephone numbers in short number blocks of
3-4 digits and to say them this way. At each break, the HFCK repeats
the number block and waits for the next number block. After the signal
tone you can respectively continue your announcement.
Enter the area code. Enter the first numbers of the actual telephone
number. Enter the remaining numbers of the actual telephone number.
When you have entered the last number block of the telephone number,
you can check the complete telephone number once again with the
voice command „PL AYBACK“. Here are some more commands:
The complete entry will be deleted, or the previous entry.
The last digit is deleted.
A telephone connection is being established.
The last number block will be deleted.
Dial Joe Bloggs
Dial number
Delete group
Dial
Delete last
Delete all