Operation Manual

15
12. Voice Dial
Introduction
With the help of the voice control, the telephone system can be
operated through spoken commands. This section explains the es
-
sential functions which can be accessed through the voice control.
Often a desired result can be reached in several ways.
The HFK itself leads you through some of the expanded functions.
If you are not sure which commands you can use in a specific menu,
say `HELP´. Then all valid commands are then listed. The HFK has
a `user training mode´ with which it can `get used to´ accents
and dialects.
For information see chapter 21.2: Voice dial.
Some voice commands can only be called up if a mobile telephone is
connected with the HFK using Bluetooth
®
.
In order to activate the voice control, apply a short press
to this field on the touch screen. The system answers with
`Head menu
´. Speak after the tone clearly in the direc-
tion of the microphone.
In order to deactivate the voice control, simply touch any part of the
touch screen again. The system answers with `Cancel
´.
When there is a longer break, the system reacts with the question `Ple
-
ase say a command now
´ and asks `Pardon?´, if a command was
not correctly understood.
Eight seconds afterwards the voice dial will be deactivated and must be
started new on the touch screen.
When entering voice commands, please ensure you speak naturally,
clearly and at a regular speed.
Note:
With the use of the voice control it is recommended to
turn down the volume of components which are indepen
-
dent of the audio system (e.g. a navigation system) or to
switch off the broadcast of traffic jam warnings in order to
avoid unintended voice entries.
