Operating instructions

12. Menu navigation

Here you will find all menus which are necessary for the operation and

configuration of the system. These can be selected through the touch

screen or using voice control.

You are also able to select additional frequently used commands via

voice control which otherwise first appear later in the menu tree. These

are as follows:

„DIAL JOE BLOGGS“,

„READ NEW TEXT MESSAGE“ and

„READ NEW EMAILS“.

You can find explanations of these in the corresponding chapters. On

the touch screen, the menus can be controlled through a simple tou-

ching of the respective field. In the following the individual menu points

will be explained.

Dial Joe Bloggs

With this voice command (is not shown on the display) you can imme-

diately call a contact from your telephone book with active voice con-

trol.

Note:

When doing so, it is important that the stated name ex- X

actly corresponds with the entry stored in the phonebook.

Please note that telephone book entries, which are only

shown in capital letters must be spelt out. Example: ADAC.

If the names have been reversed then the command changes to:

„DIAL BLOGGS JOE“.

Dial number

It makes sense to divide telephone numbers in short number blocks of

3-4 digits and to say them this way. At each break, the HFCK repeats

the number block and waits for the next number block. After the signal

tone you can respectively continue your announcement.

Enter the area code (wait a moment so that the HFCK can repeat the

entry). Enter the first numbers of the actual telephone number (wait a

moment so that the HFCK can repeat the entry.) Enter the remaining

Dial number

Dial Joe Bloggs