Operating instructions

26
Operating guidelines
Bluetooth
In the Phone list, the telephones are listed which have already been
successfully connected with the HFCK via Bluetooth
®
. The list is able to
hold a maximum of ten telephones. If an additional telephone is con-
nected then the oldest entry is deleted.
Here, every telephone can be connected, disconnected, deleted or set
as the standard. The standard telephone will always be sought as the
first telephone if the automatic connection „AUTO CONNECT ON“
has been activated. From here, the Bluetooth
®
connection can also be
made via A2DP and the playback of music initiated.
With the „CLEAR LIST“ command it is possible to delete the full tele-
phone list. You are able to assign an individual „PIN CODE“ for the
Bluetooth connection in the next menu item. Your own code must be at
least four figures long – with a maximum of eight being allowed.
The last menu item in the Bluetooth menu is the Multipoint function.
This function can only be activated via the voice control or the Touch-
screen if at least two mobile phone signatures are included in the list of
telephones. Otherwise the commands „MULTIPOINT ON“ and
„MULTIPOINT OFF“ are not available and the selection field during
operation via the Touchscreen is inactive.
Using the Multipoint function, you can operate two mobile telephones
on the HFCK in hands-free mode at the same time. The primary mobile
phone takes priority, which means that only its telephone books, call
lists, voice memos, SMS and possible emails are loaded and ready in
the memory of the HFCK. This is similar to the situation as though only
one mobile phone were connected with the HFCK. If a call is received
on the secondary mobile phone, this call will also be handled via the
HFCK. The voice feedback informs you accordingly as to which mobile
is receiving the call (the first / second telephone).
If a call is received by both mobile phones at the same time, preference
is given to the primary mobile phone. You will be displayed the inco-
ming call on the other mobile after accepting or declining the first call.
You are then able to end the first call at short notice and to also decline
the second call (pressing to the right of the red receiver both times), or
to end the first call and to accept the second call directly (press the
symbol on the left). Holding the first call isn’t possible, as the calls are
not being made on the same telephone number. The conference mode
which is described in the instructions below is not possible between the
two mobile phones.
Phone list
Clear list
Pin code
Auto connect on
Bluetooth
Multipoint on
Multipoint off