Owner's manual

ASSEMBLY

75CBH 11/11 Assembly Section 3-2

ASSEMBLY

INSTALLING PUMP KIT (Optional)

WARNING: Do not modify or alter this

implement. Do not permit anyone to modify or

alter this Implement, any of its components or

any Implement function.

1. Fasten PTO adapter (16) to hydraulic pump (6) using

5/16 x 1/2 set screws (17). Fasten hydraulic pump (6)

to pump mounting bracket (15) using 3/8-16 x 1-1/2

cap screws (18) and 3/8-16 lock nuts (21).

2. Fasten reservoir (1) to backhoe using 3/8 x 1 cap

screws (19), 3/8 flat washers (22) and 3/8 lock nuts.

3. Install 3/4 NPT x 3/4 NPT elbow fitting (8) to tank (1).

Install 3/4 x 2 nipple (13), filter assembly (9) and 3/4

NPT x 7/8 JIC elbow fitting (10) to 3/4 elbow fitting (8).

4. Install 1/2 x 30 hose (11) to filter assembly on tank.

Route hose (11) under backhoe platform and connect

to “out” port on backhoe valve.

5. Install 3/4 NPT x 7/8 JIC elbow fitting (10) to tank.

Install 1-3/16 SAE x 3/4 NPT adapter fitting (5) and 3/

4 NPT Swivel x 1-1/16 JIC elbow fitting (4) to “return”

port on pump (6).

6. Install 7/8 O-ring x 7/8 JIC elbow fitting (14) to

“pressure” port on hydraulic pump (6). Install 1/2 x 50”

hose (12) to “pressure” port on pump and “in” port on

backhoe valve.

7. Retract all cylinders. Fill reservoir to within one inch

from top with MVHO 10/30 ISO 46 hydraulic oil in

southern climates.

8. Install breather cap (2) to reservoir.

NOTE: After cycling all cylinders, recheck oil level.