Owner's manual

MAINTENANCE
75CBH 11/11 Maintenance Section 5-6
© 2011 Alamo Group Inc.
MAINTENANCE
30.This valve is a precision device and is not intended for
extensive field adjustment or repair. Field replacement
parts are limited to seal kits, cartridges and tie rod
ends. Beyond replacement of these parts, opening of
check cavities and certain relief valve cavities to
examine for trapped dirt, or resetting main relief valve
with the use of a good pressure gauge, valve should be
returned for service.
Dirt and shreds of packing material are the usual causes of
valve malfunction. Be sure that oil supply is kept clean. Use
only factory supplied packings in cylinder repair. Fittings
and hoses must be clean before being removed.
NOTE: Pay close attention to all caution warning notes so
valve will not have to be returned to manufacturer for
reconditioning.
Troubleshooting guide is designed to help qualified
individuals, with valve service training, correct minor
problems which may develop. If valve is under warranty do
not attempt disassembly for repairs. Contact your
authorized dealer. Any attempt to disassemble valve during
warranty period will VOID warranty.
13 Worn or damaged
rod seals on
cylinder. External
leaks.
Re-pack cylinder. Rebuild
cylinder replacing
damaged parts as
necessary.
14 Swing linkage
jammed.
Remove interference.
15 Excessive back
pressure.
Restriction between “in”
and “out” port and
reservoir.
16 Paint on valve spool.
Sticking valve spool,
or scored valve.
Clean valve spool. Binding
may be caused by over
tightened plug, mounting
bolt, fitting or tie rod bolt.
See Item 30.
17 Oil leakage past
spool seal into spool
cap.
If spool cap contains oil,
replace spool seal o-ring.
If o-ring retainer is
“bellied”, check for
restriction from “out” port
reservoir. See Item 30.
18 Broken return
springs.
Replace broken return
springs.
19 Bent spool. Return for factory repair or
replace with new spool
section. See Item 30.
20 Foreign particles. Clean system and valve.
21 Misalignment of
control handle
linkage.
Check linkage for binding
condition.
22 Spool not moved to
full stroke.
Spool travel should be
5/16” either way or 5/8”
total.
23 Relief valve setting
in control valve too
low or defective.
Clean or overhaul relief
valve or replace cartridge.
Refer to VALVE SERVICE
section for proper PSI
settings.
24 Overload relief valve
in control valve
stuck open or
malfunctioning.
Clean relief. Do not disturb
pressure setting or replace
cartridge.
25 Worn control valve. Replace control valve.
26 Check poppet in
control valve not
holding.
Clean check poppet(s)
carefully. Ensure free
movement and proper
seating or replace check
poppet. See Item 30.
27 Damaged or worn
spool seals.
Replace spool end seals.
POSSIBLE CAUSE CORRECTIVE ACTION
28 Check ball in anti-
cavitation is stuck or
not seated properly.
Clean anti-cavitation valve
carefully. Assure that
checks move freely and
seat properly or replace
cartridge. See Item 30.
29 Valve cap and
center return
mechanism binding.
Loosen screws holding
cap on valve (ref. Valve
Service image). Operate
valve spool and retighten
screws.
POSSIBLE CAUSE CORRECTIVE ACTION