Operating Instructions

7
Ignition of the burners
First identify the correct control knob by1.
checking the symbols above each knob as
shown in fi gure 3.
Turn the control knob fully clockwise to the2.
‘Max’ position whilst pressing in towards the
control panel as shown in fi gure 4.
Simultaneously press and hold the ignition3.
button until the gas burner is alight.
Continue to hold both the ignition button and4.
the control knob inwards for at least 5 seconds.
In the event the burner or ring fails to light,5.
repeat the process in steps 1-4 above. In the
event this still fails to operate, wait at least 90
seconds before attempting to ignite the burner.
IMPORTANT6. – This appliance is equipped with
a ‘Flame Safe Device’ (FSD). In the event that
the oven burner or gas rings are accidentally
extinguished the gas supply will be cut. Wait
for at least 90 seconds before attempting to
re-ignite the burners.
Control of the hob rings
Each control knob has 3 main positions as1.
shown in fi gure 5:
O• ff (0)
Min•
Max•
After ignition the control can be adjusted2.
anywhere between the max and min positions
to achieve the desired heat output.
To turn the hob off, rotate the control knob into3.
the ‘0’ position.
IMPORTANT – If the fl ame is seen to have a
prolonged yellow colouration, turn off the burners
and make sure the burner assembly is correctly
positioned. Wait for 90 seconds before attempting
to re-ignite the burner.
Using the hob
Figure 3
User Instructions
Cu
stomer Helpline 0345 257 7271
SERVICE AND TRANSPORT
Max
8
9
9
7
5
2
3
4
1
Max position
Figure 4
Max
Figure 5
Min
Off (O)
Figure 3