Instruction Manual

If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions,
14
Installing and Operating Your
Freezer
Before starting to use your freezer, you should pay
attention to the following points:
• Operating voltage for your freezer is 220-240
V at 50Hz.
• We cannot be responsible for any damages
that occur to this product if used incorrectly.
• Do not place your appliance in direct sunlight.
• Your appliance should be at least 50 cm away
from stoves, gas ovens and heater cores, and
should be at least 5 cm away from electrical
ovens.
• Your freezer should never be used outdoors
or exposed to rain.
• When your freezer is placed next to a
deep freezer, there should be at least 2 cm
between them to prevent humidity on the
outer surface.
• When installing the freezer, chose a suitable
place and ensure that there is a least a 15cm
gap between the top of the freezer and the
counter. Please do not place anything on top
of the freezer.
• The adjustable front legs should stabilized in
an appropriate height to allow your freezer
operate in a stable and proper way. You can
adjust the legs by turning them clockwise
(or in the opposite direction). This should be
done before placing food in the freezer.
• Before using your freezer, wipe all parts with
warm water added with a tea spoonful of
sodium bicarbonate, and then rinse with
clean water and dry. Place all parts
after cleaning.
• Install the distance adjustment
plastic (the part with black vanes at
the rear) by turning it 90° as shown
in the figure to prevent the condenser from
touching the wall.
• Freezer should be placed against a wall with a
free distance not exceeding 75 mm.
Before Using Your Freezer
• Before switching on your appliance for the
first time, ensure it is positioned in it’s desired
final location and is in it’s upright position
for at least 3 hours before plugging in and
switching on the power. Otherwise you may
damage the compressor.
• You may experience a odour from the
appliance when it is operated for the first
time. This is normal and will fade when your
appliance starts to cool.
Shipment and Repositioning
• Original package and foam may be kept for
retransportation (optionally).
• You should fasten your freezer with thick
package, bands or strong cords and follow
the instructions for transportation on the
package for retransportation.
• Remove movable parts (shelves, accessories,
vegetable bins etc.) or fix them into the
freezer against shocks using bands during
repositioning and transportation.
Carry your freezer in the upright position.
Installing your Built-Under Freezer
Installing your Built-Under Freezer
Bringing it all together