Instruction Manual

If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions,
36
Product support
Help is always at hand
If your freezer is not working properly there may be a minor problem, therefore check the following
Product support
Problem Possible Causes Possible Solutions
The appliance does not
operate
There is a power failure
The mains plug is not properly plugged
in, or is loose
The thermostat setting is on position " "
The socket is defective. To check
this, plug in a fully operable
appliance into the same socket
The appliance performs
poorly
You have overloaded the appliance
The doors are not closed perfectly
There is not sufficient ventilation
around the appliance
There is a noise The cooling gas which circulates in
the freezer circuit may make a slight
noise (bubbling sound) even when the
compressor is not running. Do not
worry, this is quite normal. If these
sounds are different check if;
• The appliance is installed firmly
as described in the section of this
instruction manual
• Objects on the appliance are
vibrating
Important notes:
• During power cut, to prevent any compressor
problem you should unplug the freezer.
You should delay pluging in 5 – 10 minutes
after your power supply returns. 0f you plug
out the freezer for a reason you should wait
at least 5 min to replug. It is important for
avoiding damage to freezer's components.
• If you will not be using your freezer for a long
time (holiday, etc...), disconnect the plug from
the socket. Clean your freezer as per chapter
6 of this document and leave the door open
to prevent any humidification or odour
formation.