Installation Manual

6710 N CATLIN AVE. • PORTLAND, OR 97203 • 503-283-4335 • 1-800-234-8920 (USA AND CANADA) • FAX [phone]
Bed Rail Cap Installation
Peel the red vinyl backing away from the pieces of
tape on the inside of the bed rail cap.
Position the bed rail cap snugly at the tail end of the
bed rail.
Carefully lay the part down on the bed rail (aligning the stake
pocket holes in the part with the stake pockets in the truck if
applicable) and apply 30 PSI to the taped areas for proper
bond. See Illustration A
Wait one hour, making sure vehicle maintains proper
temperature, and apply 30 PSI to the taped areas
AGAIN for proper adhesion to the vehicle. NOTE:
Tape reaches maximum adhesive bond after 24
hours of contact.
Slide a CL1-0006, “S” Spring Clip, onto the bed rail in
the areas where there is a bump on the inside edge
of the bed rail cap. See Illustration B & C
Fasten the bed rail cap to the clips with the SW1-
0050, 10 x 5/16 Truss Phillips Screw. See Illustration
B & C
1.
2.
3.
4.
5.
6.
Optional Stake
Pocket Hole
Illustration A
Illustration B
Illustration C
Bed Rail Cap
Bed Rail
Tape