Brochure

ManualsBrandsC&D Valve ManualsCopper Saddle ValvesBraze On Self Piercing Copper Saddle Valve for 5/16" OD Tube (6 Pack)

C&D Valve | Product Catalog | sales@cdvalve.com | 800.654.9233

BRAZE-ON SERVICE VALVES

INSTRUCTIONS

1. Prepare line and clean tube.

Remove cap and pin. Flux or

solder paste saddle and install

on line. Heat and braze copper

saddle.

2. Let cool and pressure test braze,

if desired. Insert pin with PTFE

o-ring into body. Put on cap and

tighten with wrench on body

to avoid breaking braze joint.

As cap is tightened, steel pin

penetrates tubing.

3. Last turn crimps brass edge

over top of pin for secure t and

forming ared end. Remove

cap, and tting is ready to use.

If complete penetration is not

made, put cap back on and

tighten further.

4. When work is complete, replace

cap, wrench tight for permanent

use or install new cap with

neoprene o-ring, thumb tight.

Copper-to-Copper M Series

Brass-to-Brass Bot Stinger

The M Series is the ﬁrst and best braze-on, self-piercing copper saddle valve. It is widely used and easily

installed on a charged line. After brazing the saddle portion onto line, the steel pin with valve core

penetrates the line and is locked into place simply by tightening the cap. Available in sizes ranging from

1/4” to 1-1/8”.

PART# CD5512 PKG QTY: 4

Copper saddle for 1/2” line

PART# CD5516 PKG QTY: 6

Copper saddle for 5/16” line

PART# CD5514 PKG QTY: 6

Copper saddle for 1/4” line

PART# CD2814 PKG QTY: 6

Brass saddle for 1/4” line

PART# CD2816 PKG QTY: 6

Brass saddle for 5/16” line

PART# CD2838 PKG QTY: 6

Brass saddle for 3/8” line

PART# CD2812 PKG QTY: 4

Brass saddle for 1/2” line

PART# CD2834 PKG QTY: 2

Brass saddle for 3/4” line

PART# CD2878 PKG QTY: 2

Brass saddle for 7/8” line

PART# CD2818 PKG QTY: 2

Brass saddle for 1-1/8” line

General Speciﬁcations

• Valve core and cap

• Plated steel body – CDA 360 brass saddle

• Four-way seal between body and saddle

Installation Instructions

1. Press saddle onto line ﬁrmly (use pliers)

2. Apply ﬂux and braze to line

3. Allow to cool

4. Screw body with core into saddle

5. Evacuate and charge system

6. Replace cap

PART# CD5534 PKG QTY: 2

Copper saddle for 3/4” line

PART# CD5578 PKG QTY: 3

Copper saddle for 7/8” line

PART# CD5518 PKG QTY: 2

Copper saddle for 1-1/8” line

PART# CD5558 PKG QTY: 3

Copper saddle for 5/8” line

PART# CD5538 PKG QTY: 6

Copper saddle for 3/8” line