Owner`s manual

Roof
and
below 280m
m
Within 300mm
Drain h
Drain raising
Clamp(attachment)
Ceiling
Instruction
☆ The slant gradient of the attached drain hose
should be within 75mm so that the drain hole
doesn’t has to endure the unnecessary outside force.
☆ Please install the drain hose according to the
following process if several drain hoses join together.
Drain hose(attachment)
T-tie in join drain hose
Above100
mm
The specs of the selected join drain hose should fits the running capacity of the unit.
☆
☆
☆
Check the smoothness of drain after installation.
Check the drain state by immitting 600cc water slowly from the outlet vent or test hole.
Check the drain in the state of refrigerating after installation of the electric circuit.
[Way of immiting ]
Drain hose
Test hole cover
Drain vent for repair use (plastic
stopper is included) (drain the water
in waterspout by this outlet vent)
Test hole
< Immiting water from the rest hole >
Above100
mm
Plastic water pot (The length of the
pipe should be about 100mm.)
<Immiting water from the outlet
vent terminal >
●
Warning: Before obtaining access to terminals, all supply circuits must be disconnected.
.
.
.
.
below
500m
m
.
below75m
m
below500m m
ose
hose
220mm
Hoisting
1-1.5m
st