Manualshelf

Owner`s manual

ManualsBrandsC&H ManualsAir ConditionerGUHN48NM3AO
31323334353637383940
Position and Method of Installing Wire
Controller
INSTALLATION
INSTRUCTIONS
INSTALLATION
I
NSTRUCT
I
ONS
Position and Method of Installing Wire Controller
Position and Method of Installing Wire Controller
1. One end of the control wire of the manual controller is connected with main board of electric box of
indoor unit inside, it should be tightened by wire clamp, the other end should be connected with the
manual controller (installation sketch map as shown in below). The control wire be used for the
indoor unit and manual controller, which is the special communication wire, the length is 8 meters,
the material be adopted for the control wire should be metallic substance. The manual controller
could not be disassembled and the communication wire be used for the manual controller should not
be changed by users optionally, the installation and maintenance should be carried out by the
professional personnel.
2. First select an installation position. According to the size of the communication line of the wire
controller, leave a recess or a embedded wire hole to bury the communication line.
3.
If the communication line between the wire controller
(85
x
85 x
16) and the indoor unit is
surface-mounted, use 1# metallic pipe and make matching recess in the wall (refer to Figure 41); If
concealed installation is adopted, 1# metallic pipe can be used (Refer to Figure 42).
4.
No matter if surface mounting or concealed mounting is selected, it is required to drill 2 holes (in the
same level) which distance shall be the same as the distance (60mm) of installation holes in the
bottom plate of the wire controller. Then insert a wood plug into each hole. Fix the bottom plate of the
wire controller to the wall by using the two holes. Plug the communication line onto the control panel.
Lastly install the panel of the wire controller.
Caution:
During the installation of the bottom plate of the wire controller, pay attention to the direction of the
bottom plate. The plate’s side with two notches must be at the lower position, and otherwise the panel of
the wire controller cannot be correctly installed.