Network Card User Manual

11
STEP 3 – DEVICE INSTALLATION FOR THE TRULINK WIRELESS AV ADAPTER
The TruLink Wireless AV Adapter supports two association methods: Cable Association and Pin
Association. Only one of these methods is necessary to complete installation. The instructions below
describe steps for both methods, and how to use this adapter in Wired Mode. Please note that Pin
Association is only recommended if using with a TruLink Wireless USB Host Adapter.
Do the following before installation:
 Make sure the antenna is connected to the Wireless AV Adapter.
 Plug the supplied power adapter into your Wireless AV Adapter.
 Be certain your Wireless USB host adapter is connected to the PC and necessary software has
been loaded.
 Connect the Wireless AV Adapter to your display using a VGA cable.
C
ABLE ASSOCIATION
1. Make sure the Wireless AV Adapter Wireless/Wired switch is on Wireless. Using the supplied USB
cable, connect the USB mini-b connector to the Wireless AV Adapter USB mini-B port and USB A
connector on the cable to an available USB port on your PC.
2. A cable association window pop-up will ask you if you would like to accept the association. Accept the
association and unplug the USB cable.
3. Windows will automatically install the appropriate Wireless AV Adapter drivers and you will get another
successful install message pop up verifying successful installation. The installation is now finished and
your Wireless VGA is ready for use.
SOFTWARE/DEVICE INSTALLATION