User guide
Table Of Contents
- SmartSwitch ATM Switch User Guide
- Table of Contents
- List of Figures
- List of Tables
- 1 Introduction
- 2 IP Over ATM and LANE
- 3 PNNI Routing
- 4 Routing
- 5 Virtual Ports and Static Connections
- 6 Traffic Management
- 7 Firmware Upgrades and Bootline Commands
- 8 ATM Filtering and Clocking
- 9 Troubleshooting
- Appendix A Agent Support
- Appendix B Technical Support
- Index
SmartSwitch ATM User Guide 2-19
IP Over ATM and LANE Creating an Emulated LAN
Figure 2-5 How LNNI handles ELAN join requests
Setting up LNNI LECs
The procedure for setting up LNNI on a SmartSwitch ATM switch is performed by executing the following basic steps:
• Shut down all LANE services — LECS, LES and BUS
• Configure LNNI
• Enable LNNI
• Start LANE services
The following is an example of enabling LNNI on a network and configuring neighbor LECSs on two separate
switches (SW1 and SW2).
Client D
Client A
Client B
Client C
LES/BUS
LES/BUS
LECS 0 LECS 1
LES/BUS
Logical full mesh
among LES/BUS
switches