User`s guide
Table Of Contents
- TITLE PAGE
- NOTICE
- CONTENTS
- INTRODUCTION
- INSTALLATION REQUIREMENTS/SPECIFICATIONS
- INSTALLATION
- CONNECTING TO THE NETWORK
- TROUBLESHOOTING
- LOCAL MANAGEMENT
- EPIM INFORMATION
- IMAGE FILE DOWNLOAD USING OIDs
- INDEX
EPIM SPECIFICATIONS
SEHI USER’S GUIDE A-3
A.1.3 EPIM-F3
The EPIM-F3 shown in Figure A-3 supports Single Mode Fiber Optic
cabling. It has an internal Cabletron Systems FOT-F Fiber Optic
Transceiver and is equipped with ST Connectors. Specifications for the
EPIM-F3 are listed below.
Figure A-3. EPIM-F3
Note: Transmitter Power decreases as temperatures rise and increases as
temperatures fall. Use the Output Power Coefficient to calculate increased
or decreased power output for the operating environment. For example,
the typical power output at 25
°
C is -16.4 dBm. For a 4
°
C temperature
increase, multiply the typical coefficient (-0.15 dBm) by four and add the
result to typical output power (4 x -0.15 dBm + -16.4 = -17.0).
1490_32