Specifications

98 IBM Voice Over Frame Relay Perform Guide
4.2.3.6 IBM 2212 A Configuration Steps
1. To configure the frame relay parameters:
2. To configure the FXS adapter:
3. To configure the FXO adapter:
3
4
5
6
7
8
Rule DLCI and
subchannel for
processing
DLCI and
subchannel for
payload
Dial
Match
Rule
Network Output
Rule
.
.Config (only)>SET HOSTNAME 2212-A
Host name updated successfully
Config (only)>SET DATA-LINK FRAME-RELAY 0
Config (only)>NETWORK 0
Frame Relay user configuration
FR 0 Config>ENABLE FRAGMENTATION
Specify the fragmentation type to be done [UNI/NNI Fragmentation]? e
Fragment size (50 to 8190) [256]?
Fragmented packet reassemby timer (3 to 10 seconds) [3]?
FR 0 Config>ENABLE CIR-MONITOR FR 0 Config>DISABLE LMI
FR 0 Config>ADD PERMANENT-VIRTUAL-CIRCUIT
Circuit number [16]?
Committed Information Rate (CIR) in bps [64000]?
Committed Burst Size (Bc) in bits [64000]?
Excess Burst Size (Be) in bits [0]?
Assign circuit name []? to 2212-B
Is circuit required for interface operation [N]?
Enable circuit for voice forwarding [N]?
Do you want to have end-to-end fragmentation performed [N]? y
Fragment size (50 to 8190) [256]?
Fragmented packet reassemby timer (3 to 10 seconds) [3]?
FR 0 Config>EXIT
Config (only)>
Config (only)> ADD DEVICE VOICE-FXS
1996 more interfaces may be configured.
Device Slot #(1-5) [1]?
Adding 2 Voice FXS devices in slot 1 as interfaces 4 - 5.
Use "net 4" - "net 5" to configure Voice FXS parameters.
Config (only)>NETWORK 4
2212-A Voice 4 Config>SET LOCAL-NUMBER 111
Number of leading digits used for local call routing (1 to 3) [3]?
2212-A Voice 4 Config>SET VAD MODE ADAPTIVE
2212-A Voice 4 Config>EXIT
Config (only)>