Specifications

102 IBM Voice Over Frame Relay Perform Guide
4.2.3.7 IBM 2212 B Configure Steps
1. To configure frame relay parameters:
2. To define the voice E&M function:
1 To define PBX as immediate start or wink start; default is immediate start.
2 To define PBX as Type 1, 2 or 5.
3 To define PBX as 2-wire or 4-wire; default is 4-wire.
3. To define frame relay interface for voice:
Config (only)>SET HOSTNAME 2212-B
Host name updated successfully
Config (only)>SET DATA-LINK FRAME-RELAY 0
Config (only)>NETWORK 0Frame Relay user configuration
2212-B FR 0 Config>ENABLE FRAGMENTATION
Specify the fragmentatin type to be done [UNI/NNI Fragmentation]? e
Fragment size (50 to 8190) [256]?
Fragmented packet reassemby timer (3 to 10 seconds) [3]?
2212-B FR 0 Config>ENABLE CIR-MONITOR
2212-B FR 0 Config>DISABLE LMI
FR 0 Config>SET CABLE V35 DCE
FR 0 Config>SET CLOCKING INTERNAL
Must also set the line speed to a valid value
Line speed (2400 to 2048000) [0]? 2048000
2212-B FR 0 Config>ADD PERMANENT-VIRTUAL-CIRCUIT
Circuit number [16]?
Committed Information Rate (CIR) in bps [64000]?
Committed Burst Size (Bc) in bits [64000]?
Excess Burst Size (Be) in bits [0]?
Assign circuit name []? to 2212-A
Is circuit required for interface operation [N]?
Enable circuit for voice forwarding [N]?
Do you want to have end-to-end fragmentation performed [N]? y
Fragment size (50 to 8190) [256]?
Fragmented packet reassemby timer (3 to 10 seconds) [3]?
2212-B FR 0 Config>EXIT
Config (only)>
Config (only)>ADD DEVICE VOICE-EM
1996 more interfaces may be configured.
Device Slot #(1-5) [2]? <-Solt
Adding 2 Voice E&M devices in slot 1 as interfaces 4 - 5.
Use "net 4" - "net 5" to configure Voice FXS parameters.
Config (only)>NETWORK 4
Voice 4 Config>SET START WINK 1
Voice 4 Config>SET TYPE 5 2
Voice 4 Config> 3
Config (only)>FEATURE VOICE
2212-B Voice Config>SET FR-NET 0