Specifications

176 IBM Voice Over Frame Relay Perform Guide
5.4.2.2 Release Causes
The following list presents release-cause messages and their meanings.
5.4.2.3 Call Processing Circuit Statistics
The SHOW PERFORMANCE CALL_PROCESSING < group#> < circuit#> command provides
useful call statistics such as the fail causes (the reason a circuit cannot be
seized), the number of seize attempts made, and the number of seizes
completed.
The following table describes the information provided by this command.
CAUSE OF LAST RELEASE SENT
TO NET
Displays the cause of the last release message that was sent to the network.
ALTERNATE ROUTE TO VFAX The number of calls rerouted to another Vfax port after failing to set up a call on
this voice port.
ALTERNATE ROUTE TO
NETWORK
The number of calls rerouted to network after failing to set up a call on this
voice port.
SRC DIGITS
Digits after outbound address translation. Src digits is blank if outbound
translation fails.
DIAL DIGITS
Dialed digits after outbound address translation. Dial digits is blank if outbound
translation fails.
Message Description
0X07 INBOUND TRANSLATION
FAILED
This message indicates that the remote side rejected the call.
0X08 OUTBOUND TRANSLATION
FAILED
This message indicates that an outbound call could not be completed because
the outbound address translation failed.
0X09 REMOTE VFAX BUSY This message indicates that an outbound call could not be completed because
the remote voice port is busy.
0X0A REMOTE VFAX NO
RESPONSE
This message indicates that an outbound call could not be completed because
the remote voice port did not respond to the call setup request. This usually
indicates that either the remote voice port is down or it is not (physically) there.
0X0B OUTBOUND TIMEOUT
This message indicates that an outbound call has time-out waiting for a
response from the remote side.
0X02 NO LOCAL BAND-WIDTH
This indicates that the local circuit group does not have enough bandwidth to
set up the call.
0X03 NO REMOTE BANDWIDTH This indicates that the remote circuit group does not have enough bandwidth to
set up the call.
0X04 CHANNEL BUSY
This indicates that the remote side is busy.
0X0F MAX HOPS EXCEEDED This indicates that the call traversed more than 10 hops; therefore, the call was
aborted.