Specifications

Command Summary 207
R2 M
ode Format: ca R2 m mode
Sets the mode (mode) of operation for R2
processing. Mode: NORMAL, PULSE_DISABLED,
or LINE_ONLY
R2
R
equest_category
Format:caR2rd
Sets the digit (d) that is the IBM 9783 looks for in
order to issue the Calling_Category digit.Digit: One
character (0-9, A-C, *, or #). Default: 5.
R2 Send_(N-1)
Format: ca R2 send_(N-1 d
Sets the digit (d) that the IBM 9783 looks for in order
to issue the digit it sent prior to the last one. Digit:
One character (0-9, A-C, *, or #). Default: 2.
R2 Send_(N-2) Format: ca R2 send_(N-2 d
Sets the digit (d) that the IBM 9783 looks for in order
to issue the digit it sent prior to the last two. Digit:
One character (0-9, A-C, *, or #). Default: 7.
R2 Send_(N-3) Format: ca R2 send_(N-3 d
Sets the digit (d) that the IBM 9783 looks for in order
to issue the digit it sent prior to the last three. Digit:
One character (0-9, A-C, *, or #). Default: 8.
R2 Send_first Format: ca R2 send_f d
Sets the digit (d) that the IBM 9783 looks for in order
to issue the first digit it sent during the current
dialing sequence. Digit: One character (0-9, A-C, *,
or #). Default: 0.
R2
Subscriber_free
Format: ca R2 subscriber_f d
Sets the digit (d) that is used by Group I to notify an
R2 subscriber whether or not thechannel is free. In
Normal R2 mode, this command applies to both
incoming and outgoing calls. In Pulse_disabled
mode, it applies to incoming calls only. Digit: One
character (0-9, A-C, *, or #). Default: 6.
R2
Subscriber_OOS
Format: ca R2 subscriber_o d
Sets the digit (d) that, if detected during the
incoming session, signals the release of the call.
This command is applicable only when the IBM
9783 is operating as an outgoing register. Digit: One
character (0-9, A-C, *, or #). Default: 8.