Specifications

210 IBM Voice Over Frame Relay Perform Guide
Warble_t/o Format: ca warble_ d
Sets duration of silence (d) after a disconnect before
warble is generated. Range: 0-10000-64000 msec.
Cycle voice ports offline and back online to
complete the update.
Wink_delay Format: ca wink_del d
Sets delay (d) following incoming seize after which
wink is generated by AVFAX card, E&M port, or
E-1/T-1 port. Range: 0-50-64000. Cycle voice ports
offline and back online to complete the update.
Wink_detect_t/o Format: ca wink_det p
Sets timeout period (p) after which, if a wink is not
received, a call is aborted. Range: 0-2000-64000
msec. Cycle voice ports offline and back online to
complete the update.
Wink_duration Format: ca wink_du d
Sets duration of wink signal (d) generated by AVFAX
card, E&M port, or a DSUB T-1/E-1port. Range:
0-200-10000. Cycle voice ports offline and back
online to complete the update.
Channel (ch) Command
Data port (dp): all (all), specific data port (a1, a2, a3, a4, b1, b2, b3, or b4) or a range (i,e., a1-a3)
Connect Format: ch c dp d1 dp d2 p ipadd:udp ipadd:idx nms
dp dlci
Establishes a data connection in the IBM 9783 unit
between device 1 (d1) and device 2 (d2).
Connections can be established between:
1. Accounting channel (d1) and FRAD port in
ASCII_ASYNC mode (d2),
2. CP channel (d1) and frame relay DLCI or
subDLCI (d2),
3. FRAD port (d1) and frame relay DLCI or
subDLCI (d2), or
4. Frame relay DLCI or subDLCI (d1) and FRAD or
other DLCI or subDLCI (d2).
This command also specifies the IP and UDP
addresses (ipadd:udp) when ACCOUNTING is
selected for the port. When the port has been
designated a voice port, specify the IP address and
designated index number (ipadd:idx). This
command also establishes priority (p) as h (high) or
n (normal).