Specifications

Command Summary 211
D
isconnect Format: ch d dp d1 dp d2 ipadd:udp ipadd:idx nms
dp dlci
Disconnects a PVC connection in the IBM 9783 unit
that was previously created using the channel
connect command (ch c dp d1 dp d2 p). This
command also specifies the IP and UDP addresses
(ipadd:udp) when ACCOUNTING is selected for the
port. When the port has been designated a voice
port, specify the IP address and designated index
number (ipadd:idx).
Circuit_Group (ci) Command
Circuit group (cg): all (a) or 1-128. Individual circuits (c): processing (p) or 2-255. Data port (dp): all
(all), specific data port (a1, a2, a3, a4, b1, b2, b3 or b4) or a range (i,e., a1-a3). DLCI(d1): 16-991.
Subchannel/SubDLCI(sc): 1-254.
Add_circuit Format: ci cg a c p dp:dl:sc
Adds a circuit (c) or a call processing channel (p) to
a circuit group (cg), which is assigned to dp:dl:sc.
The DLCI and subDLCIs must already be created.
Data port dp must be online.
Connect_to_node Format:cicgcon
Connects a circuit group (cg) to a remote IBM 9783
node. Node (n) is a remote device’s four-digit node
address.
Create (cir-cuit
group)
Format:cicgcr
Creates circuit group cg.
Delete circuit Format:cicgdc
Deletes circuit c from circuit group cg.
Inbound_trans_
rule
Format:cicginbn
Assigns an inbound translation rule by rule number
(n) to circuit group (cg). Translation rule number:
0-3.
Index Format:cicgindidx
Assigns the index number (i) for the designated
circuit group. Use this command to establish
multiple circuit groups between two nodes. This is
necessary when the con-nected nodes are using
both frame relay and ethernet IP. cg: 1-127, ALL.
idx: 0-127.
Max_cir Format:cicgmcir
Assigns a maximum Committed Information Rate
(cir) to circuit group cg. cir range:
8-384000-2048000 bps