Specifications

212 IBM Voice Over Frame Relay Perform Guide
Remove Format:cicgr
Removes circuit group cg. All circuits in circuit group
cg must be deleted (ci cg de a) before circuit group
cg can be removed.
Console_Port (co) Command
Alarm Format: co a (e or d)
Controls whether alarms display on the console as
they occur. Enter e (enable) or d (disable).
Local_prompt Format: co l prompt
Customizes the local prompt. Enter a string of up to
eight characters (prompt) to display with the LOCAL
prompt and identify an IBM 9783 unit. Note: If first
five characters of the prompt spell CLEAR, there will
be no local prompt.
Local_prompt
Clear
Format: co l clear
Removes the local prompt string, entered with the
Local_prompt command, that displays with the
LOCAL prompt and identifies an IBM 9783 unit.
Note: CLEAR cannot be abbreviated.
Rate Format:cordr
Changes the console port data rate (dr). Data rate:
300, 1200, 2400, 4800, or 9600 bps.
Terminal Format:cott
Designates the console port terminal type (t) as a
(ASCII) or v (VT100).
Data_Port (da) Commands
Data port (dp): all (all), specific data port (a1, a2, a3, a4, b1, b2, b3, or b4) or a range (i,e., a1-a3)
Block_size Format:dadpbbs
Sets the data block size (bs) for data port dp. Block
size: any number divisible by 4 from 64-96. Default =
64. Data port dp must be offline.
Clear_stat Format:dadpcle
Clears data port dp statistics.
Clock_mode Format:dadpclom
Sets the clock mode (m) for data port dp. Clock
mode can be i (internal), e (external), s(split) or t
(tx_loop). Data port dp must be offline.