Specifications

Command Summary 217
A
sync_config Format: frad dp a p1 p2
Configures data port dp to async protocol for FRAD
operation. Configure both p1 and p2, when
applicable:
p1 p2
b (Build_timeout) 10-50-5000 milliseconds.
c (Character_bits) 5 (5 bits), 6 (6 bits), 7 (7 bits), or
8(8bits).
p (Parity) n (none), e (even), or o (odd).
st (Stop_bits) 1, 1.5, or 2 (clock cycles).
sub_(Sub_char) 0-255.
subs(Substitute) e (enable) or d (disable).
Data port dp must be offline.
BERT Format:fraddpbem
Sets the bit error rate test (BERT) mode (m). Mode:
d (disable), i (internal) or e (external)
Bisync_config Format:fraddpbip1p2
Configures data port dp to BISYNC protocol for
FRAD operation. Configure both p1 and p2 when
applicable:
p1 p2
7 (7-bit ASCII) h (high), l (low), E (even), or O (odd)
8 (8-bit ASCII - default) Not applicable
e (EBCDIC) Not applicable
i (Idle_line_fill i (idle) or s (sync).
m (Min_syn_pair) 1-16 (character pairs).
p (Pad_char_code) 0-255 or D (default).
s (Sync_char_code) 0-22-255 or D (default).
Data port dp must be offline.
CIR Format:fraddpccir
Sets FRAD port dp committed information rate (cir).
cir : 8-2048000 bps. Data port dp must be
configured to FRAD mode and offline.