Specifications

218 IBM Voice Over Frame Relay Perform Guide
EIR Format:fraddpeeir
Sets FRAD port dp excess information rate (eir). eir
: 8-2048000 bps. Data port dp must be configured to
FRAD mode and offline.
Flow_control Format:fraddpflp1p2
Configures flow control for FRAD port dp. Configure
both p1 and p2 when applicable. p1 p2
i (input) e (enable) or d (disable).
o (output) e (enable) or d (disable)
t (type) c (CTS/DTR) or x (XON/XOFF).
Data port dp must be offline.
Fragmentation Format:fraddpfrsn
Configures the size of frame relay packets (s) into
FRAD port dp by setting the number of blocks (n) in
a packet. The number of bytes in a block of data is
set using the data port block size command (da dp b
bs). Number of blocks: 1-18. Data port dp must be
configured to FRAD mode and offline.
HDLC_config Format: frad dp h p1 p2
Configures data port dp to HDLC protocol for FRAD
operation. Configure both p1 and p2 when
applicable:
p1 p2
c (CRC_siz) 1 (16 bits) or 3 (32 bits).
i (Idle_line_fill) i (idle) or f (flag).
l (Line_encoding) nrz or nrzi.
m (Min_flags) 1-2-16.
Data port dp must be offline.
Mode Format:fraddpmp
Configures FRAD port dp protocol (p). Protocol: asc
(ASCII_async: for call accounting channel), asy
(async), b (bisync), or h (HDLC_SDLC). Data port
dp must be offline.