Specifications

Command Summary 219
S
ignalling Format: frad dp s ms p1 p2
Configures FRAD port dp modem signalling by
selecting modem signal (ms) and the on-state
condition (p1) of the modem signal. Additional
signalling conditions are shown as p2 when they are
required. Modem signal: c (CTS), dc (DCD) or ds
(DSR). Configure both p1 and p2 when applicable.
Signalling condition:
p1 p2
of: Off_force N/A
on: On_force N/A
local_r: Local_RTS 0-500 msec
local_d: Local_DTR 0-500 msec
r:RTS N/A
d:DTR N/A
a: And_RTS_DTR N/A
or: OR_RTS_DTR N/A
Data port dp must be offline.
TC Format:fraddptct
Configures the time (t) allocated as Committed Rate
Measurement Interval (tc), on which calculation of
the CIR and EIR are based. Time: 10-1000-5000
msec. Data port dp must be configured to FRAD
mode and offline.
Traffic_shaping Format:fraddptrs
Set the operational state (s) of IBM 9783 traffic
shaping function on FRAD port dp to e(enable) or d
(disable). Data port dp must be configured to FRAD
mode.
Frame_Relay (fram) Command
Data port (dp): al (al), specific data port (a1, a2, a3, a4, b1, b2, b3, or b4) or a range (i,e., a1-a3). DLCI
(d1): 16-991. Subchannel/SubDLCI (sc):1-254.
DLCI CIR Format: fram dp d dl ci cir
Sets the committed information rate (cir) for DLCI dl
on frame relay port dp. cir: 8-2048000 bps..
DLCI Clear_stat Format:framdpddlcl
Clears performance statistics pertaining to DLCI dl
on frame relay port dp.