Specifications

220 IBM Voice Over Frame Relay Perform Guide
DLCI Create Format:framdpddlcr
Creates DLCI dl and assigns it to frame relay port
dp. DLCI type (t): n (normal) or b (bundled). A DLCI
must be bundled if subDLCIs will be assigned to it.
Place port online.
DLCI Delete Format: fram dp d dl de
Deletes DLCI dl from frame relay port dp. SubDLCIs
that have been assigned to the DLCI must be
deleted before the DLCI can be deleted, and the
DLCI must be set to the Disable condition (fram dp d
dl di).
DLCI Disable Format: fram dp d dl di
Disables DLCI dl on frame relay port dp. All DLCIs
must be disabled before the data port to which they
are assigned can be placed offline. When a DLCI is
disabled, it does not support packet traffic.
DLCI EIR Format: fram dp d dl ei eir
Sets the excess information rate (eir) for DLCI dl on
frame relay port dp. eir : 8-2048000 bps.
DLCI Enable Format: fram dp d dl en
Enables DLCI dl on frame relay port dp to enable
communication of frame relay traffic.Frame relay
port dp must be online before the DLCI can be
enabled.
DLCI Fragmenta-
tion
Size
Format:framdpddlfsb
Configures fragmentation on DLCI dl of frame relay
port dp by setting fragmentation size (s). When
enhanced fragmentation is selected, select the
number of blocks (b) in a fragment. Size: 1-18.
Fragmentation is not valid for a bundled DLCI.
DLCI Fragmenta-
tion
Type
Format:framdpddlftb
Configures fragmentation on DLCI dl of frame relay
port dp by setting fragmentation type (t) to
enhanced. Type: n (none) or e (enhanced).
Fragmentation is not valid for a bundled DLCI.
Default = none
DLCI
Sub_channel
Format:framdpddlsscs
Configures subDLCI (subchannel) sc as part of
bundled DLCI dl, on frame relay port dp, and sets
the subDLCI state (s) to c (create) or d (delete). sc:
1-254; 4-254 for FRF.11