Specifications

Command Summary 223
Q
uit Format:q
Ends an IBM 9783 console session and returns the
display to the ENTER PASSWORD prompt. Always
conclude a console session by entering the Quit
command. Remote (Rem) Command
Remote (Rem) Command
Remote Format:rem
Sets the IBM 9783 unit to the remote command
mode. In this mode, the unit processes only
commands intended for execution by the remote unit
selected by the Select_remote_node (se) command.
The command prompt will be REMOTE>.
Reset (Res)Command
Voice port (vp): all (al), a specific voice port (v1-v for analog voice ports; v1a-v8d for digital voice ports)
or a range (i,e., v1a-v2d).
DSUB Format:Resd
Resets the DSUB card. This command places the
DSUB in the reset mode, downloads code to the
DSUB, and reinitializes it.
Voice_ports Format:resvvp
Resets voice port vp. This command places the
voice port in the reset mode, downloads code to the
voice port, and reinitializes it.
Select Remote Node (se) Command
Se
lect_remote_no
de
Format:seid
Selects a remote IBM 9783 unit that the unit
accesses when any remote command is executed.
Remote node id: Last number of the IP address.
IBM 9783 units are shipped by IBM with no remote
nodes selected.
Show (sh) Commands
Circuit group (cg): all (a) or 1-128. Individual circuits: processing (p) or 2-255. Data port (dp): all (al),
specific data port (a1, a2, a3, a4, b1, b2, b3 or b4) or a range (i,e., a1-a3). DLCI (d1): 16-991. DS0
channel (ch): T-1: port (v1-v8 for analog voice ports; v1a-v8d for digital voice ports) or a range (i,e.,
v1a-v2d).
Config Callpro Format:shcca
Displays call processing parameters.
Config Channels Format:shcch
Displays permanent virtual connections.
Config
Circuit_group
Format: sh c ci cg
Displays the configuration of circuit group cg.