Specifications

Command Summary 229
S
end_code
Format:us
Downloads software and firmware code from the
local unit to the unit specified by the
Select_remote_node (se) command. Code
download can require 40 minutes across a
terrestrial link or 90 minutes over a satellite link.
Caution: If the network link is interrupted during a
download, wait four minutes after return of green
SYNC indication before executing another
Send_code.
Time
Format: u ti hh:mm:ss
Sets the IBM 9783 unit’s internal clock. Enter two
digits each to specify hour:minute:second (i.e.,
09:38:20).
Type
Format: u ty nt ac
Changes the unit type identifier to the type specified
in the new type parameter (nt). This command also
can ENABLE_NMS or DISABLE_NMS; ENABLE_IP
or DISABLE_ IP; and ENABLE_20-MIPS or
DISABLE_20-MIPS. This command can be used
only with the auth_code (ac) parameter. Refer to
Unit Authorize command, above. Notes: 1. This
command is reserved for authorized personnel only
, 2. An auth_code is required for installing a 20
MIPS voice card into an IBM 9783 unit. 3.
Caution:
Changing the unit type with this command resets
the unit .
Unmap_node
Format: u un id dp: dl: sc
Removes a control processing (cp) channel from an
IBM 9783 unit. Refer to Unit Map_node command
above. Note: This command must be issued from
both IBM 9783 units in the link.
Update_hw
Format:uup
Updates the IBM 9783 unit’s internal reference
hardware configuration record. This record stores
circuit card assembly (CCA) types resident in the
unit.
Bit
Format:vvpb
Executes the built-in tests that are performed during
power-up or unit reset on voice port vp. Voice port
vp must be offline.