Specifications

Command Summary 233
Te
lco FXS
Format
: v vp te fxs l r
Selects telco Foreign Exchange Subscriber (FXS)
interface for voice port vp. Follow fxs with l
(indicating loop_start) or G (indicating
ground_start), and the ring mode (r). Ring mode: i
(inter_ring) or c (cont_ring). Default=loop_start
inter_ring.
Caution: Changing telco parameters interrupts
communication through the voice port.
Telco OOS
Format:vvpteos
Selects the signalling response (s) from voice port
vp when it is Out of Service (OOS) as a result of a
voice port offline command (v vp of) or a prolonged
voice channel sync loss. Signalling response: b
(busy, for AVFAX port use), i (idle, for AVFAX port
use), or a four-bit pattern (for DVFAX port use). The
default four-bit pattern is 1111.
Caution:Changing telco parameters may interrupt
communication through the voice port.
Telco Signalling
Format: v vp te si st
Selects the signalling state (st) for digital voice
channel vp. Signalling state: 2 (2-state), 4 (4-state),
or 1 (16-state).
Caution: Changing telco parameters
may interrupt communication through the voice port.
Telco Termination
Format: v vp te te i
Selects impedance termination (i) for AVFAX port
vp. This command is not valid for DVFAX ports.
Impedance termination: 6 (600 Ohms for domestic
or international connections), 9 (900 Ohms for
domestic connections only), or c (complex for
international connections only).
Caution: Changing
telco parameters may interrupt communication
through the voice port.
Telco Translate
Format: v vp te tr t1 t2
Specifies two translation tables for voice port vp.
Each table is comprised of 16 hex characters. One
table (t1) is for translating signalling from the local
unit’s voice port to the remote unit’s voice port; the
other table (t2) is for translating signalling from the
remote unit’s voice port to the local unit’s voice port.
This command is valid only for DVFAX ports.
Caution: Changing telco parameters may interrupt
communication through the voice port.