Specifications

24 IBM Voice Over Frame Relay Perform Guide

5. If the power-up sequence is successful, a Nuera greeting message, like the

one shown below, is displayed on the terminal screen, followed by the

software version number.

Note: The Please Wait...Initializing Unit message means that the unit is

starting up. System configurations will not be lost during this process.

6. The unit performs a series of internal self-test routines that require

approximately 5 minutes. As the unit completes each self-test routine,

messages display confirming that the unit has passed each of the tests listed.

Verify that all the ports installed in the unit pass the tests.

7. Immediately following self-test confirmation, a series of alarm messages

display. This is a normal indication, because the network, voice, and data

ports have not yet been installed.

8. The Enter Password prompt displays. If passwords have not been set for the

IBM 9783 unit, press the Enter key to access the IBM 9783 command

structure, and set two levels of password protection using the

password

command described in the following section.

3.1.1 Assigning Passwords

IBM 9783 units are shipped from the factory with no preassigned passwords.

Passwords that can be set include:

• System

• WinLoader

• Telnet

The

password command permits two levels of access to IBM 9783 commands. IBM

9783 FRADs are controlled by the use of separate passwords, one for each

access level. Passwords can be formed of any combination of alphanumeric

characters, up to 30 characters long.

Nuera Communications -- Access Plus F200 NMS IP

Please Wait.... Initializing Unit.

RAM/ROM Test: Passed

E2PROM Test: Passed

Watchdog Test: Passed

TOD Test: Passed

I/O Port Test: Passed

CPI Test: Passed

GDI Test: Passed

Vfax/Dataport BIT Test:

FMX : Passed

Stack A (DSUB ) : Passed

Stack B (HSP ) : Passed

Slot V1 (VFAX ) : Passed

Slot V2 (VFAX ) : Passed