Specifications

Installation and Configuration Activities 33
For example:
FRAD A2 HDLC_CONFIG CRC 16_BITS
9. Configure the flow control setting. The choices are:
•TYPE
• INPUT
•OUTPUT
For example, to select CTS/DTR flow control for FRAD A2, issue the following
command:
FRAD A2 FLOW_CONTROL TYPE CTS/DTR
10.Configure the maximum fragment size by entering an integer from 64 to 255,
divisible by 4. For example, the following command selects a fragment size of
64 for FRAD A2:
FRAD A2 FRAGMENT 64
11.. Configure the modem signals. The choices are:
• OFF_FORCE
• ON_FORCE
• LOCAL_RTS_DELAY
• LOCAL_DTR_DELAY
• TRANSPARENT RTS
• TRANSPARENT DTR
• TRANSPARENT AND_RTS_DTR
• TRANSPARENT OR_RTS_DTR
For example, to cause the remote DTR input signal to drive the local CTS
signal for FRAD A2, issue the following command line:
FRAD A2 SIGNALLING CTS TRANSPARENT DTR
12.. Configure out of service modem signaling. The choices are:
• OFF_FORCE
• ON_FORCE
•FREEZE
For example, to force CTS ON for FRAD A2, issue the following command line:
FRAD A2 OOS_SIGNALLING CTS ON_FORCE
13.Set the CIR, EIR, and T c settings for the FRAD port. The following example
sets the CIR for FRAD A2 to 16000.
FRAD A2 CIR 16000
14.Issue the following command to turn the data ports online or offline.
DATA_PORTS A2 ONLINE