Specifications

42 IBM Voice Over Frame Relay Perform Guide
2. Issue these commands for Unit 2:
CHANNEL CONNECT CP A1:18:4
CHANNEL CONNECT CP A2:20:4
3. Issue these commands for Unit 3:
CHANNEL CONNECT CP A2:20:4
CHANNEL CONNECT CP A3:22:4
4. Issue the following command for Unit 4:
CHANNEL CONNECT CP A3:22:4
5. Issue these commands to map the units to Unit 1:
UNIT MAP 3 A1:18:4 *
UNIT MAP 4 A1:18:4
Because IBM 9783 FRADs dynamically map to the first sequential unit, you do
not need to issue a UNIT MAP command between Unit 1 and Unit 2.
6. Execute the following command to verify that the unit recognizes the CP
network:
SHOW REMOTE_NODES
(You may experience a delay between the execution of the MAP UNIT
commands and the updated SHOW_REMOTE_NODES response.)
7. Before sending console interface commands to another unit, you must
establish a CP connection to that unit. Use the following command, replacing
<node_id> with the number of the desired node:
SELECT_REMOTE_NODE < node_id>
3.4 Configuration of VoFR in IBM 2212 Access Utility
This section explains the configuration of the IBM 2212 Access Utility for voice
over frame relay network.
3.4.0.1 Voice Interface Configuration
To configure a voice port, enter the network command plus the number of the
voice port.
Config> network n
Where n is the interface number.
To configure a voice port, enter the following commands at the Voice n Config>
prompt:
Table 14. Voice Port Command
Use the SET command to specify the setting for a specific voice port.
Voice n Config>SET NODE-ID
LOCAL-NUMBER
TELCO-OUTPUT-RULE
Command Function
SET Sets various voice port parameters
LIST Lists various voice port setting