Specifications

Installation and Configuration Activities 43
RX-GAIN
TX-GAIN
... OOS
TYPE (E&M)
WIRE (E&M)
... START (E&M)
... SUITE
... RATE
FRAME-PACKING
... ECHO-CANCEL
... VAD
... FAX
Where:
NODE-ID Specifies the IP address of the voice port. The range is any
valid IP address. The default is 0.0.0.0.
LOCAL-NUMBER Specifies the local telephone number of the voice port. The
range is any 20-digit(0-9, A-D, *,#) number. The default is 0.
TELCO-OUTPUT-RULE Specifies which telco-output-rule to be used. The range
is 0-8 (upper limit depends on the number of
Telco-output-rules that have been defined. The default is 0.
RX-GAIN Specifies the amount that the voice port attenuates (or
amplifies) the receive signal. The range is from -16 dB to
+7dB. The default is -4 dB.
TX-GAIN Specifies the amount that the voice port attenuates (or
amplifies) the transmitted signal. The range is from -16 dB to
+7 dB. The default is -4 dB.
OOS Specifies the type of tone you want to use to indicate that the
specified voice port is out-of-service. You can choose
eitheridle(1) or busy(2). The default is busy.
TYPE (E&M-only) Specifies the telco E&M interface for the specified voice port.
You can choose either 1, 2, or 5. The default is 1.
WIRE (E&M-only) Specifies the whether you are using a 2-wire or 4-wire telco
connection. You can specify either 2(2-wire) or 4(4-wire).
The default is 4.
START (E&M-only) Specifies how the voice port starts its transmissions. You can
choose either immediate start(1) or wink start(2). The
default is immediate start.
SUITE Specifies the type of protocol you want the voice port to use.
You can choose either NUERA-ECELP/G.726(2) or
ITU-G.729/G.7258/G.726(3). The default is NUERA.
RATE Specifies the transmission rate of the voice port. If you
specify Nuera as the suite parameter, you can choose either
4.8 KB, 7.5 KB, 9.6 KB, or 32 KB. If you specify ITU as the
suite parameter, you can choose either 8 KB, 16 KB, or 32
KB. The default is 9.6 KB.