Specifications

Installation and Configuration Activities 45
1. At the OPCON prompt, enter talk 6.
* talk 6
2. At the CONFIG prompt, enter the feat voice command.
Config> feature voice
3. To configure a voice adapter, enter the following commands at the
VoiceConfig> prompt.
Table 16. Voice Feature Configuration Commands
ADD Command
Use the ADD command to add a call-processing-rule, dial-digit-rule and
network-output-rule.
Voice Config>ADD CALL-PROCESSING-RULE
DIAL-MATCHING-RULE
NETWORK-OUTPUT-RULE
TELCO-OUTPUT-RULE
CALL-PROCESSING-RULE
: For outgoing calls, call processing rules are evaluated in
ascending order by comparing the dialed digits to the dial digit matching rule
associated with each call processing rule. If a match is found, the network output
rule and call routing information in the call processing rule are used to process
the call. Up to eight calls processing rules can be defined for each voice port.
Note: The call processing rule combines a network output rule and a dial
matching rule with call routing information (DLCI and subchannel specification in
the case of a remote call route, number of destination digits to compare to local
numbers in the case of a local call route.)
Command Function
ADD Adds a call processing, dial-matching, or output rule.
DELETE Remove a call-processing, dial-matching, or output
rule.
LIST Lists various timer and tone setting.
MODIFY Updates a call-processing, dial-matching, or output
rule.
REORDER-CALL-RULE Changes the search order of the call processing rule.
SET Sets timers, tones, and FR-Nets (frame relay nets).
EXIT Returns you to the previous command level.
Voice Net [0]? 6
Define Call Processing Rule #2
Destination Type (Local or Remote) [Remote]? Remote
Call Processing DLCI (16 to 1007) [16]? 16
Payload DLCI (16 to 1007) [16]? 16
Call Processing Subchannel (4 to 254) [4]? 4
Payload Subchannel (4 to 254) [4]? 5
Dial Digit Matching Rule Number (0 to 3) [0]? 2
Network Output Rule Number (0 to 2) [0]?2