Specifications

Installation and Configuration Activities 47
Use the SET TONE command to set the following tone parameters:
•
SET TONE BUSY:Specifies the characteristics of up to two frequencies used to
generate the busy signal.
•
SET TONE DIAL: Specifies the characteristics of up to two frequencies used to
generate a dial tone.
first-digit-timeout The time during the first digit must be
received.
0-1000 10000
glare-detect-timeout The time before a port can seize a
channel.
0-500 500
inter-digit-timeout The time during a digit must be received
after the first digit is received.
0-10000 10000
ring-no-answer-timeout The time that a voice channels rings a
FXO port while waiting for an answer
before abandoning the call
0-64000 10000
ring-on detect-timeout The time of the presence of ringing at an
FXO port before the server determines
that the ringing has stopped.
0-64000 6000
ring-on detect-timeout The time of the presence of ringing at an
FXO port before the ringing is
recognized.
0-64000 400
seize-detect-delay The time before a seize signal is
recognized.
0-500 50
start-dial-delay the time after receipt of a dial signal but
before digits are transmitted
0-64000 500
warble-timeout the time of silence needed after a
disconnect before a warble signal is
generated.
0-64000 10000
wink-detect-timeout the time after which, if a wink is not
received, a call is ended.
0-64000 2000
wink-duration the duration time of the wink signal. 0-10000 200
wink-start-delay the time after receipt of a incoming seize
signal, that a wink signal is generated.
0-64000 50
Voice Config>SET TONE BUSY
On1 (0 to 32767 ms) [500]?
Off1 (0 to 32767 ms) [500]?
On2 (0 to 32767 ms) [500]?
Off2 (0 to 32767 ms) [500]?
Freq1 (300 to 3000 Hz) [480]?
Freq2 (300 to 3000 Hz) [620]?
Level1 (-7 to -22 dB) [-20]?
Level2 (-7 to -22 dB) [-20]?