Specifications

Installation and Configuration Activities 49
3.4.0.3 Voice Adapter Monitoring
This section summarizes the voice adapter monitoring commands. Use the
following procedure to access the voice interface monitoring process. Detailed
information on monitoring is explained in “Performance Tuning, and Monitoring”
on page 157.
At the OPCON prompt, enter the following command:
* talk 5
4. At the MONITOR prompt, enter the network command plus the number of the
voice port.
Config> network 6
5. To monitor a voice port, enter the following commands at the Voice n Config>
prompt.
Table 18. Voice Adapter Configuration Command
Figure 20. The CALLS Command
Command Function
CALLS Displays the statistics of the call processing at the port.
STATUS Displays the status of the port.
TRACE Trace the voice packets of the port.
Voice Config>SET TONE WARBLE
On1 (0 to 32767 ms) [100]?
Off1 (0 to 32767 ms) [100]?
On2 (0 to 32767 ms) [100]?
Off2 (0 to 32767 ms) [100]?
Freq1 (300 to 3000 Hz) [1400]?
Freq2 (300 to 3000 Hz) [2060]?
Level1 (-7 to -22 dB) [-16]?
Level2 (-7 to -22 dB) [-16]?
2212-yokohama Config>CALLS
vent Counters
Seize Detected 14 Digit Detected 46
Seize Applied 0 Digit Generated 0
Message Counters
Setup Sent 9 Setup Received 0
Connect Sent 0 Connect Received 2
Answer Sent 0 Answer Received 1
Release Sent 16 Release Received 2
Release Cause Counters
Normal 1 Response 1
Busy 0 OOS 0
Local Bandwidth 0 Incompatible 0
Remote Bandwidth 0