Specifications

Sample Scenarios 81
2. To modify tone busy and fast-busy:
4.2.1.8 Summary of This Sample Configuration
• Each 2212 can contain up to four voice adapter cards with each card
containing two voice ports for a total of eight ports. The ports can have FXS,
FXO, or E&M interfaces.
• Local Call Routing: Calls can be made between two ports on the same 2212
without using 9783. It can be done by configuring one of eight call processing
rules on each port for local call routing
• A local number is configured for each voice port that has a local call rule
defined. You can specify the number of leading digits to be compared in each
port’s local number. The network output rule, specified in a local route call
rule, must specify enough destination number digits to correctly route the call.
Because the source voice ports and the destination voice ports are within the
same 2212, a local routing call rule does not contain DLCI information or
subchannel information.
• Dial Match Rule specifies a dial digit pattern-matching sequence in which
each element of the sequence specifies the range of acceptable digits at that
position.
• Network Output Rule specifies the destination number digits to be passed in
the frame relay call setup packet. The sequence is specified as a combination
of the dialed digits received on the originating telco port and constants.
• For out-going calls, call processing rules are evaluated in ascending order by
comparing the dialed digits to the dial digit matching rule associated with each
call processing rule. If a match is found, the network output rule and call
routing information in the call processing rule are used to process the call. Up
to eight call processing rules can be defined for each voice port.
• Destination Type specifies whether the destination node is on another
2212/9783 (Remote) or a another voice port on the same 2212 (Local).
• It is possible to change dial tones using the
SET TONE DIAL, SET TONE RING-BACK,
SET TONE BUSY, SET TONE FAST-BUSY
commands.
2212B Voice Config>
SET TONE BUSY
On1 (0 to 32767 ms) [500]?
Off1 (0 to 32767 ms) [500]?
On2 (0 to 32767 ms) [500]?
Off2 (0 to 32767 ms) [500]?
Freq1 (300 to 3000 Hz) [480]?
400
Freq2 (300 to 3000 Hz) [620]?
400
Level1 (-7 to -22 dB) [-20]?
Level2 (-7 to -22 dB) [-20]?
2212A Voice Config>SET TONE FAST-BUSY
On1 (0 to 32767 ms) [300]?
500
Off1 (0 to 32767 ms) [300]?
500
On2 (0 to 32767 ms) [300]?
500
Off2 (0 to 32767 ms) [300]?
500
Freq1 (300 to 3000 Hz) [480]?
400
Freq2 (300 to 3000 Hz) [620]?
400
Level1 (-7 to -22 dB) [-16]?
Level2 (-7 to -22 dB) [-16]?