Installation guide
23 24
SPEAKER
1 Ω MINIMUM
REM
POWER
SPEAKER
1 Ω MINIMUM
REM
POWER
When bridging two D1800M OR D2500M ampliers together, the nal impedance load of the bridged ampliers
should be no lower than 2-ohms. Double power will occur at 2-ohms.
When bridging two D800M OR D1600M ampliers together, the nal impedance load of the bridged ampliers
should be no lower than 4-ohms. Double power will occur at 4-ohms.
Master ampliers positive (+) speaker terminal should be wired to the positive terminal of the subwoofer.
Slave ampliers positive (+) speaker terminal should be wired to negative terminal of the subwoofer.
Now connect a heavy gauge wire (12 Gauge) between the negative (-) terminal of the Master amplier and the
Negative (-) terminal of the Slave amplier.
Please see diagram on previous page for a detailed drawing.
When daisy chaining two ampliers for independent woofers, wire up the the woofers as you would typically wire
them when installing individual systems, even down to 1-ohm. By using the MASTER/SLAVE input conguration
you gain the advantage of having one ampliers’ preamp section control both ampliers, eliminating the need to
gain match and crossover match your system between ampliers.
TWIN AMPLIFIER BRIDGING
IMPORTANT NOTE:
CONNECT THE TWO SPEAKER NEGATIVES
TOGETHER WITH A # 12 WIRE STRAP.
D1800M / D2500M
SUBWOOFER
MINIMUM IMPEDANCE
2 OHMS WITH 2 AMPS BRIDGED
*
FOR D800M / D1600M
MODELS, SUBWOOFER
MINIMUM IMPEDANCE
4 OHMS WITH 2 AMPS BRIDGED
TWIN AMPLIFIER BRIDGING