Installation guide

4 Ω BRIDGED
REM
CH2 CH1
CH4 CH3
POWER
SPEAKER
13 14
Channels 1 and 2 should be
wired to speakers no lower
than 2 ohm loads per channel
in stereo. Channel 3 and 4
should be bridged as per the
diagram wiring the woofer to
Channel 3 positive side (+)
and Channel 4 negative side
( – ) terminals.
Set the crossover mode
switch of Channels 1 and
2 to either Full Range or
High Pass, while Channels 3
and 4 should be set to Low
Pass. Remember that the
Dashboard Bass Remote
Control works only on Low
Pass Channels.
Please see page 11 for RCA
input conguration details
and instructions when wiring
a 3 channel system.
4 CHANNEL AMPLIFIER IN 3 CHANNEL MODE
LEFT SPEAKER
2-4 OHM
RIGHT SPEAKER
2-4 OHM
SUBWOOFER
MINIMUM IMPEDANCE
4 OHMS
CH 1-2
CROSSOVER MODE SWITCH
IN HIGH PASS POSITION
CH 3-4
CROSSOVER MODE SWITCH
IN LOW PASS POSITION
CH3-CH4
GAIN
CH1-CH2
GAIN
0.2V7V
0.2V7V
CH3-CH4
CLONE FR/HP
LP/BP FR/HP
BASS
REMOTE
REMOTE SUBWOOFER
LEVEL CONTROL,
CHANNELS 3-4 ONLY
(optional, see dealer for
details)
4 Ω BRIDGED
REM
CH2 CH1
CH4 CH3
POWER
SPEAKER
When bridging the four channel amplier,
make sure that your nal woofer
impedance on each bridged channel is
no lower than 4 ohms. Set the Crossover
Mode Switch to Low Pass and begin by
setting the crossover frequency control
to 100Hz and tuning from there. The
dashboard bass remote control works
only on channels set to Low Pass.
4 CHANNEL AMPLIFIER BRIDGED TO 2 CHANNELS
CH 1-2
CROSSOVER MODE SWITCH
IN CLONE POSITION
CH 3-4
CROSSOVER MODE SWITCH
IN LOW PASS POSITION
RIGHT SUBWOOFER
MINIMUM IMPEDANCE
4 OHMS
LEFT SUBWOOFER
MINIMUM IMPEDANCE
4 OHMS
CH3-CH4
GAIN
CH1-CH2
GAIN
0.2V7V
0.2V7V
CH3-CH4
CLONE FR/HP
LP/BP FR/HP
BASS
REMOTE
REMOTE SUBWOOFER
LEVEL CONTROL
(optional, see dealer for details)